Efapel 21311 Manual Del Usuario página 11

BLINDS CONTROLS
DESCRIPTION
They allow manual or automatically, the general or individual control
of blinds, according to the programmed schedule or the surroundings
conditions (ambient light, wind, etc.), measured by associated sensors. They
can be operated at the local or remotely by using an IR transmitter (Infrared
transmitter).
USE INSTRUCTIONS
- Up - Down
Press the key
time, press the same key.
PROG. (only for General Blinds Control)
Press the PROG. key until the LED start blinking. Press the desired function
- down functions) the corresponding LED to the programmed
( - up or
function will blink. The programmed function will be repeated after 24 hours.
STANDBY - Programming suspension (only for General Blinds Control)
The STANDBY function allows suspending the programming without deleting
it. It can be reactivated without being necessary a new programming. To
activate or deactivate the stand-by function, press the STANDBY key for 5
seconds and then the corresponding function key which programming is
supposed to be suspended. The corresponding LED will blink at shorter time
intervals. To suspend both functions, press the STANDBY key for 5 seconds
and then both keys (
or to up or down the blind. To stop the movement at any
- up or - down functions).
EN
11