Publicidad
Idiomas disponibles
Idiomas disponibles
high-pressure spray to wash away the cleaner.
USE OF CLEANING AGENTS
A HIGH-PRESSURE CLEANER SPRAYS CLEANING
AGENT UNDER LOW PRESSURE. USE ADJUST-
ABLE SPRAY TO RINSE AND CLEAN.
BIO-DEGRADABLE CLEANING AGENTS ARE
INTENDED ESPECIALLY FOR
TO PROTECT THE ENVIRONMENT AND YOUR
PRESSURE CLEANER THESE
THE CLEANING AGENTS DO NOT CLOG THE
FILTER AND PROTECT THE INTERNAL PARTS OF
THE HIGH PRESSURE CLEANER FOR ITS LONG
LIFE.
Separate the nozzle from the detergent tank by turn-
ing the detergent tank counterclockwise and separat-
ing the two parts.
Fill the tank with an approved cleaning agent. Pour
the cleaning agent into the reservoir slowly using a
funnel. Reinstall both parts by reinserting the nozzle
back onto the detergent tank and turning it clockwise.
To apply the cleaner to the work surface, connect the
cleaner nozzle to the gun. Turn the high pressure
cleaner to the ON position. Pull the trigger to start the
device. A high-pressure cleaner mixes water with a
cleaning agent. Do not let the cleaning agent dry on
the surface of the cleaned object.
WARNING: NEVER USE PRODUCTS WITH
BLEACH OR CHLORINE
NOR WITH OTHER AGGRESSIVE MATERIALS,
INCLUDING LIQUIDS CONTAINING SOLVENTS (I.E.
GAS, OIL), PRODUCTS WITH SODIUM TERTIARY
PHOSPHATE, AMMONIA OR ACID BASED CLEAN-
ERS. THESE CHEMICALS WILL DAMAGE THE
EQUIPMENT AND CAUSE DAMAGE EVEN ON THE
CLEANED SURFACE. ALWAYS READ THE LABEL.
To clean the work surface, remove the cleaning agent
and attach the adjustable nozzle to the gun. Spray
the work surface with high-pressure water and rinse
to remove any remaining cleaner.
Unblock the nozzle with a cleaning needle
When the nozzle is clogged, pressure will build up
in the pump, which can cause a violent jet from the
device. You can clean the nozzle by inserting a nee-
dle into the tip to loosen the deposits.
With an adjustable nozzle, you can regularly lubri-
cate the nozzle collar (high-pressure or low-pressure)
with water-insoluble grease.
Self-priming enables the suction of water from tanks,
buckets, barrels or streams up to a maximum length
of 50 cm. The dishwasher must be used in a vertical,
safe and stable position. It is IMPORTANT that the
water inlet filter is clean and in place and that only
clean water is drawn in.
However, it is important to ensure that the level of
the water drawn in is at least at the level of the dish-
washer, therefore it is not possible to draw water from
deep wells, etc. The water must be clean. Ideally, the
dishwasher can be supplied with water from a suit-
able larger container or tank.
▪ Submerge the suction hose completely under water
to expel the air.
▪ Connect the suction hose to the device and make
sure that the suction filter remains under water.
▪ Operate the device without the hand-held spray
gun attached until water flows evenly from the high-
pressure hose. If the water does not flow after 1
minute, turn off the device and check it. Once the
water is flowing, turn off the device and connect the
hand spray gun and spray tube to get to work. It is
important that the hose and coupling are properly and
firmly mounted.
58
Publicidad
