camry CR 5024 Manual De Uso página 4

iron, may still be in hot water.
18. DO NOT allow for prolonged contact hot steam iron with fabric or flammable materials.
19. Be careful that the power cord does not touch the hot soleplate. Allow the iron to cool
completely before storage.
20. If you do not use iron, even for a short time, turn off the options of steam
21. Under no circumstances should be ironed clothes and fabrics that are on humans or
animals.
22. Never direct the steam to humans or pets.
23. Iron must be used at a stable even surface and this can only be disposed of.
24. Do not fill the water tank with chemicals, perfumes or descaling substance.
25. It is recommended to install the residual current device (RCD) whose rated differential
current does not exceed 30 mA for additional protection. In this area you turn to a specialist
electrician.
DESCRIPTION OF DEVICE
A. S oleplate
C. Steam Control Lever
E. Foldable handle
G. Water tank
I. Thermostat knob - temperature control
IRONING
First use
When using the iron for the first time, you may notice a slight emission of smoke and hear some sounds made by the expanding plastics. This is
quite normal and it stops after a short time. We also recommend passing the iron over an ordinary cloth when using it for the first time.
Preparation
Sort the laundry to be ironed according to the international symbols on the garment label, or if this is missing, according to the type of fabric.
GARMENT
LABEL
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool down) and eliminates the risk of scorching the fabric.
STEAM IRONING
Check that the plug is disconnected from the socket. Move the steam selector (C) to "0" . Open the lid (B). Raise the tip of the iron to help
the water enter the opening without overflowing. Slowly pour the water into the reservoir using the special measure and taking care not to
go over the maximum level (about 40ml) indicated by "MAX" on the reservoir. Close the lid (B). Place the iron in a vertical position. Plug it
to the electricity. Set the thermostat knob in accordance with the international symbol on the cloth's labels. Thermostat control light
indicates that the iron heats up. Wait until the indicator light off. You can then start ironing.
Warning: When you ironing, the thermostat control light turns on from time to time, this means that the selected temperature is maintained
at a constant level. If you decrease temperature, do not begin ironing again until the thermostat light does not light up.
Warning: The iron gives off steam continuously only if you hold the iron horizontally. You can stop the continuous steam by placing the
iron in a vertical position or by moving the steam selector to "0". As indicated on the thermostat knob (I) and in the initial table, you can
only use steam at the highest temperatures. If the selected temperature is too low, water may drip onto the plate.
Ironing without steam
To ironing without steam, turn steam regulation lever (C) to 0 position.
PROCEDURE AFTER IRONING
B. The water inlet hole
D. "Steam blast" button
F. Power Cord
H. Thermostat indicator light
J. Handle release button
FABRIC
TYPE
synthetic
silk - wool
Cotton - linen
Fabric not to be ironed
ENGLISH
4
THERMOSTAT
REGULATION
·
low temperature
··
medium temperature
···
high temperature