Publicidad
Idiomas disponibles
Idiomas disponibles
If the battery symbol appears in the measuring window resp. if a critical charge of battery is shown in the status, the
batteries have to be changed IMMEDIATELY. If you do not use your device for a longer period, remove the batteries. For
eventual resulting damages we cannot provide any warranty.
Determination of the material reference moisture
The device FLK-2 determines the water content, which means that it calculates the moisture referred to the total mass:
Mn - Mt
% F =
Mn
Cooling time
If you measure in very fast intervals and bales with a high density the measuring head can become warm because of the
friction. These can lead to fault measurements! Let your device cool down during the measurements.
Digit calibration curve
The digit curve is a unitless calibration curve with a range from 0 up to 100% which corresponds to the entire measure-
ment range of the device. With this curve special products can be measured. The higher the value is, the wetter the mate-
rial is. Using a comparative measurements to a reference method a table with comparison values can be created with this
reference values
Exemption from liability
For miss-readings and wrong measurements and of this resulting damage we refuse any liability.
This is a device for quick determination of moisture. The moisture depends on multiple conditions and multiple materials.
Therefore we recommend a plausibility check of the measuring results.
Each device includes a serial number and the guarantee stamp. If those are broken, no claims for guarantee can be made.
In case of a faulty device please contact your dealer.
x 100
very dry: 0
Mn:
Mass with average moisture content
Mt :
Mass of the dried sample
%F:
Calculated absolute moisture
(water content) (according to norm: CEN/TS 14774)
very wet: 100
18
Publicidad
