EINHELL TC-AC 190 OF Set Manual De Instrucciones Original página 20

6.5 Instructions for the adapter set
For information on the correct use of the adapters
for the various valves, please refer to the following
overview (see Fig. 7 which shows how to connect
the adapter to the compressor).
•
Ball needle (Fig. 4)
Area of application: For infl ating balls. The
ball needle can be used to infl ate a variety of
diff erent balls.
TIP: To avoid damaging the valve, moisten
the needle slightly before inserting it.
•
Valve adapter (Fig. 5)
Area of application: For Dunlop and Presta
cycle tire valves.
This valve adapter is designed for infl ating
cycle tires.
•
Conical universal adapter (Fig. 6)
Area of application: The universal adapter can
be used for infl ating airbeds and other similar
items.
Danger! Never direct the jet of compressed air at
yourself or at any other persons or animals.
Caution! Infl ating objects to above the recom-
mended pressure level may cause damage to the
objects or harm to bystanders!
6.6 What to do in case of an abnormal/emer-
gency situation
1. Stop the operation
2. Switch off the equipment.
3. Pull the power plug
6.7 After using
1. Switch off the equipment.
2. Pull the power plug
3. Remove all accessories from the equipment
such as, e.g. hose, tire pressure gauge, etc.
4. If the equipment is going to be cleaned or
repaired, allow it to cool down fi rst.
5. Check the equipment for signs of damage.
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
Anl_TC_AC_190_OF_Set_SPK13.indb 20 Anl_TC_AC_190_OF_Set_SPK13.indb 20
GB
8. Cleaning, maintenance and
ordering of spare parts
Hazard!
Pull out the power plug before doing any
cleaning and maintenance work on the
equipment.
Danger!
Wait until the compressor has completely
cooled down. Risk of burns!
Danger!
After use, always switch off the equipment
immediately and pull out the power plug.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment im-
mediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be ag-
gressive to the plastic parts in the equipment.
Ensure that no water can get into the interior
of the equipment. The ingress of water into
an electric power tool increases the risk of an
electric shock.
•
You must disconnect the hose and any
spraying tools from the compressor before
cleaning. Do not clean the compressor with
water, solvents or the like.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
8.3 Storage
Danger!
Pull the mains plug out of the socket and ventilate
the appliance and all connected pneumatic tools.
Switch off the compressor and make sure that it is
secured in such a way that it cannot be started up
again by any unauthorized person.
- 20 -
08.05.2023 08:35:08 08.05.2023 08:35:08