SNOWJOE SUNJOE 24V-X2-21LM Manual Del Operador página 12

Side discharge door
Side discharge
chute
Grooves
3. Release the side discharge door.
Mulching Plug Assembly + Fitting
Your mower is equipped with a mulching plug to allow the
blade to cut and recut the grass for finer clippings.
NOTE: When using the mulching plug, do not assemble the
grass collection bag or the side discharge chute.
NOTE: When the grass collection bag is not attached, the
mulching plug must be inserted in the rear discharge opening.
1. Lift up the ejector flap.
2. Insert the mulching plug fully into the rear discharge
opening and make sure it's seated securely (Fig. 12).
3. Release the ejector flap.
Operation
This lawn mower is intended for private residential use to cut
grass in small lawns and gardens. This lawn mower is not
intended to cut grass in public parks, playing fields, farms or
forests. Do not use this lawn mower for any application other
than that for which it is intended.
Adjusting the Cutting Height
This cordless lawn mower is equipped with a 7-position height
adjustment lever to tailor grass cutting heights from 1.2 in. to
3.5 in. (30 mm to 90 mm). To change the cutting height of the
grass, follow the instructions below.
m
Fig. 11
the batteries and the safety key from the lawn mower and wait
until the rotating blade has come to a complete standstill.
ALWAYS FOLLOW ALL SAFETY PRECAUTIONS AND
RECOMMENDATIONS LISTED PREVIOUSLY IN THIS
MANUAL.
1. Power off the lawn mower and remove the batteries and
Underside
2. Push the cutting height adjustment lever to the outside of
Pins
3. Insert the lever into the desired slot.
Fig. 12
Ejector flap
Mulching plug
Rear
discharge
4. Reinsert the batteries and the safety key to the lawn
opening
Starting + Stopping
m
that it is not in contact with any foreign objects. Keep your
hands and feet a safe distance away from the rotating mower
blade and the ejector opening. Failure to comply with these
warnings can result in severe personal injury.
IMPORTANT: Do not start the mower in tall grass.
1. Make sure the unit's switch lever is not squeezed on.
12
WARNING!
Before making these adjustments, remove
the safety key.
the original slot (Fig. 13).
Height
adjustment lever
Fig. 13
7-Position Height Adjustment (From front to rear):
(1) 1.2 in. (30 mm)
(2) 1.6 in. (40 mm)
(3) 2.0 in. (50 mm)
(4) 2.4 in. (60 mm)
(5) 2.8 in. (70 mm)
(6) 3.1 in. (80 mm)
(7) 3.5 in. (90 mm)
mower and resume normal use.
WARNING!
Before switching on the mower, make sure
Insert the batteries and the safety key in their slots
(Fig. 14). Close the battery compartment cover.