Publicidad
Idiomas disponibles
Idiomas disponibles
Contents of Carton
1 - Air Compressor
2 - Wheels
2 - Shoulder Bolts, 3/8
2 - Hex Nuts, 3/8
2 - Rubber Bumpers
2 - Screws, 1/4-20 x .75"
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
Unpacking
1.
Remove all packaging leaving
the air compressor on the pallet.
2.
Remove and discard the (4)
screws holding the air
compressor to the pallet.
Screws
or support one side of the air
compressor when removing the
pallet because the air compressor
will have a tendency to tip.
3.
Carefully remove the air
compressor from the pallet.
A00844
ASSEMBLY
It may be
necessary to brace
Assemble Wheels
one side of the air compressor
when installing the wheels because
the compressor will have a
tendency to tip.
1.
Attach wheels with shoulder
bolts and nuts as shown.
Nut
2.
Tighten securely. NOTE: The air
compressor will sit level if the
wheels are properly installed.
provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
Assemble Rubber Feet
1.
Attach rubber feet with the
screws provided as shown in
previous figure.
2.
Tighten securely.
10- ENG
It will be necessary
to brace or support
Rubber
Feet
Screw
Wheel
Shoulder
Bolt
The wheels and
handle do not
Publicidad
