Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO SET UP THE SCOOTER
Assembly of the scooter
MAKE SURE THE KICKSTAND IS UNFOLDED BEFORE PREPARING THE
NEXT SETUP:
1.
Position the handlebars using the stem in line with
the steering column.
2.
Tighten the 2 M5 screws of the stem as tight as
possible.
3.
Once the handlebars are positioned and tight,
position the steering column cover and tighten it with
the center screw..
4.
Find the correct angle and position of the brake
lever by tightening the screw with the 4mm Allen key.
IF ANY OF THE ITEMS MENTIONED ARE MISSING, IMMEDIATELY CONTACT THE STORE WHERE YOU PURCHASED THIS
SCOOTER.
HANDLING THE SCOOTER AFTER ITS COMMISSIONING: IF THE SCOOTER IS STILL IN THE FOLDED POSITION, WE ADVISE
YOU TO MOVE IT WITH THE HELP OF A SECOND PERSON HOLDING BOTH ENDS OF THE VEHICLE TO LIFT IT IF THE
SCOOTER IS UNFOLDED, PLACE YOUR TWO HANDS ON BOTH HANDLEBARS, YOU CAN THEN MOVE IT BY PUSHING IT
WHILE WALKING NEXT TO IT
ONCE THE ASSEMBLY IS COMPLETE, YOU CAN START THE SCOOTER, MAKING SURE YOU HAVE FOLDED THE STAND.
PLACE ONE FOOT ON THE PLATFORM AND STEP FORWARD WITH A FORWARD PUSH ON THE FLOOR WITH THE OTHER
FOOT WITHOUT USING THE ACCELERATOR. AND MAKE SURE THAT BOTH OF YOUR HANDS ARE POSITIONED ON THE
BRAKE LEVERS. YOU MUST REACH A SPEED OF 4KM / H FOR THE VEHICLE TO START
14
USER MANUAL - EN
ADJUST THE FOLLOWING ITEMS ACCORDING TO YOUR DRIVING
PREFERENCE:
• dashboard support
• the dashboard switch
• the accelerator and the lighting stalk
• the horn
Then screw them in properly using the supplied tool
kit.
Publicidad
