Publicidad
Idiomas disponibles
Idiomas disponibles
4
Installation and Adjustment of the Temperature Knob
Failure to do so may cause injury.
A. Adjust temperature limit stop!
Turn on water supplies; LET THE WATER RUN AT
BOTH FULL HOT AND FULL COLD TO ENSURE
THE WATER IS RUNNING AS HOT/COLD AS
POSSIBLE. Place a thermometer in a plastic tumbler,
and hold the tumbler in the water stream. Place the
temperature knob (1) onto the splines (2), then rotate
the temperature knob counter-clockwise until you
achieve your maximum desired temperature from the
outlet (not more than 120° or the lower temperature
mandated by your local plumbing code).
B-1.
2
1
Secure the temperature knob using screw (1) and
place cap (2) on knob.
B-2B.
4
Snap temperature control cover over temperature
control knob by first aligning smaller tab (1) on cover
with receiving slot (2) on temperature knob. Swing
larger tab (3) to engage with snap feature (4). Note:
If dis-assembly is required, reverse this motion,
disengaging larger tab (3) from snap feature (4) first.
107530 Rev. F
A.
1
2
4
3
1
2
1
If max temperature is not achieved before limit stop
(3) on temperature knob (1) meets the limit stop (4) on
the volume control handle. Remove the temperature
control knob (1) from splines (2). Rotate temperature
control knob (1) clockwise. Place temperature control
knob (1) back onto splines (2) and continue to rotate
counter-clockwise until maximum desired temperature
is achieved.Remove the temperature knob (1) and
replace onto the splines (2), making sure that the
temperature knob limit stop (3) hits against the volume
handle limit stop (4) as shown.
B-2A.
4
Secure temperature control knob (1) with screw (2).
Hook (3) front of temperature control cover (4) onto
knob (1) before engaging rear snap (5).
B-3.
3
Attach spacer screw (1) to valve stem (2). Slide
temperature control handle (3) into place over spacer
screw (1) and secure using set screw (4). Cover with
decorative button (5).
6
4
3
1
5
2
3
1
2
3
5
4
Publicidad
