Carat DPZ0200000 Manual De Instrucciones página 12

M18FHSAG125, AGV13-125XSPDEB,
M18FSAGV125, AGV15-125, AGV13-125,
AG13-125XSPD, AGV12-125 type
B
• Take Support Bar off from [B]
Adapting Unit.
3. Switch the Lower Brackets position when the gearcase size D of the angle grinder
is larger than 47mm.
For D<47mm grinder
(Factory default)
D < 47 mm
4. Place [B] Adapting Unit on gearcase of the grinder. [E] Offset Plate or [F] Milwaukee Plate must
be set on gearcase for some grinders.
9558 D28134,
type DCG412N
type
B
Gearcase
22
Support
Bar
#15
For D>47mm grinder
D > 47 mm
L1400125 HD18 M18FHSAG125, AGV13-125XSPDEB, M18FSAGV125,
type type AGV15-125, AGV13-125, AG13-125XSPD,
AGV12-125 type
F
E
5. Hold [B] Adapting Unit and
push its dent at bottom
until it stops
For some grinders, match the
shape of grinder's gearcase with
the center hole of [B] Adapting
Unit then hold it from the top.
9565 / GA5021 / GA5030 / GA5040 / M18FHSAG125, AGV13-125XSPDEB,
GA5041 / DGA511 / DGA515 / DGA504 / M18FSAGV125, AGV15-125, AGV13-125,
DGA513 / DGA517 type AG13-125XSPD, AGV12-125,
AGV10-125 type
WPB18LTXBL125 / WB18LTXBL125 /
WP18LTX125 / W18LTX125 / WEV1500-
125 / WE1500-125 / WEV850-125 /
WP850-125 / W850-125 / W750-125 type
B
B
HD28AG-125, AGV17-125, AG16-125,
AG8-125, AG9-125 type
(OLD type)
L3410FR, L3410VR type
23