Descargar Imprimir esta página

Proline PAC1800 Manual De Instrucciones página 33

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Storage
If you are not using the appliance for an extended period of time. After cleaning please:
Turn o and unplug the appliance.
Make sure the water is completely drained.
Run the appliance on FAN mode for 12 hours in a warm room to dry it and prevent
mould.
Clean the lter as described in the previous section.
Remove batteries from the remote control.
Cover the appliance and store it upright in a location where it will not receive direct
sunlight.
Problem
Unit does not turn on
when pressing ON/OFF
button.
Unit does not cool well.
The unit is noisy and
vibrates too much.
The unit makes a gurgling
sound.
TROUBLESHOOTING
Possible Cause
P1 Protection Code
In COOL mode: room
temperature is lower than the
set temperature.
E0 EEPROM error
The air lter is blocked with
dust or animal hair.
Exhaust hose is not connected
or is blocked.
The unit is low on refrigerant.
Temperature setting is too high.
The windows and doors in
the room are open.
The room area is too large
There are heat sources inside the
room.
The ground is not level.
The air lter is blocked with dust
or animal hair.
This sound is caused by the ow
of refrigerant inside the unit.
32
Solution
Turn o the unit, drain the water
and restart the unit.
Reset the temperature.
Contact the service agents or a
similar quali ed person for service.
Turn o the unit and clean the
lter.
Turn o the unit, disconnect the
hose, check for blockage and
reconnect the hose.
Call a service technician to inspect
the unit and top o refrigerant.
Decrease the set temperature.
Make sure all windows and doors
are closed.
Check the cooling area.
Remove the heat sources if
possible.
Place the unit on a at, level
surface.
Turn o the unit and clean the
lter.
This is normal.
EN

Publicidad

loading