Attwood 11901 Manual Del Propietário página 8

TROUBLE SHOOTING
PROBLEM
No reading on the ammeter
Ammeter readings stays high Battery is severely dis-
Charger will not turn on
when properly connected
POSSIBLE CAUSE
Charger is not plugged
in.
No power at the recep-
tacle.
Clips are not making a
good connection to the
battery.
Connections are re-
served.
Battery is defective ( will
not accept a charge)
2 amp charge rate is be-
ing used.
charged.
Wrong battery voltage.
AC outlet is dead.
8
REASON/SOLUTION
Plug the charger into an A.C. outlet.
Check for open fuse or circuit
breaker supplying A.C. outlet.
Check for poor connection to battery
and frame. Make sure connection
points are clean. Rock clips back and
forth for a better connection.
Unplug the charger and reverse the
clips.
Have battery checked.
Ammeter may show no activity at
the 2A charge rate.
Continue charging battery for two
more hours. If problem continues
have the battery checked.
Verify the voltage settings or output
ratings on the charger are correct.
Check for open fuse or circuit
breaker supplying AC outlet.