Attwood 11901 Manual Del Propietário página 9

PROBLEM
The battery is connected and
the charger is on, but is not
charging
The measured current is
much lower than what was
selected
Ammeter reads less than
selected charge rate when
charging a discharged bat-
tery
POSSIBLE CAUSE
Poor electrical connec-
tion
Clips are not making a
good connection.
The charger reached the
maximum voltage and is
reducing the current.
Extension cord is too
long or wire gauge is too
small.
Weak cell or sulfated
plate in battery.
Use a shorter or heavier
gauge extension cord.
9
REASON/SOLUTION
Check power cord and extension
cord for loose fi tting plug.
Check for poor connection at battery
and frame. Make sure connecting
points are clean. Rock clips back and
forth for a better connection.
No problem, this is a normal condi-
tion.
Battery is partially discharged
A sulfated battery will eventually
take a normal charge if left con-
nected. If the battery will not take a
charge, have it checked.
Continue to charge the battery.