Elite 2G10i Manual De Usuario página 23

3） GROUND (Earth)
Make sure to ground (earth) the generator.
OPERATION
NOTE:
•The generator has been shipped without engine oil. Fill with oil or it will not start.
•Do not tilt the generator when adding engine oil. This could result in overfilling and damage to the engine
1） STARTING THE ENGINE
NOTE:
Before starting the engine, do not connect the electric apparatus.
1. Open the fuel tank air vent to the OPEN position.
2. Turn the fuel cock lever to the ON position.
3. Turn the engine switch to the ON position
4. When first time to use the generator sets, pressing the primer bulb 6 times after refuel gasoline
5. Turn the choke lever to the │ │CHOKE position. Not necessary if the engine is warm.
6. Pull the starter handle slowly until resistance is felt. This is the Compression point. Return the handle to its
original position and pull swiftly. Do not fully pull out the rope. After starting, allow the starter handle to return
to its original position while still holding the handle. Grasp the carrying handle firmly to prevent the generator
from falling over when pulling the recoil starter.
7. Warm up the engine.
8. Turn the choke lever back to the │ │RUN position.
9. Warm up the engine without a load for a few minutes.
OPEN
ON
ENGINE
SWITCH
STOP
ON
www.ELITETOOLS.co
Keep Working
5