Desoutter SLC030-P1200-C4Q Manual De Instrucciones página 8

6159934940_05
Original instructions.
© Copyright 2020, Ets Georges Renault 44818
St Herblain, FR
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
STATEMENT OF USE
Tool (class I) suitable for industrial environment
only.
It shall be used for tightening or loosening joints
in wood, metal or plastic material.
No other use permitted.
For professional use only.
DATA
(See page 4).
Noise level: < 70 dB(A) (EN 60 745).
Vibration level: < 2.5 m/s² (EN 60 745).
Declaration of noise and vibration emission
All values are current as of the date of this
publication. For the latest information please visit
desouttertools.com.
These declared values were obtained by
laboratory type testing in accordance with the
stated standards and are suitable for comparison
with the declared values of other tools tested
in accordance with the same standards. These
declared values are not adequate for use in risk
assessments and values measured in individual
work places may be higher. The actual exposure
values and risk of harm experienced by an
individual user are unique and depend upon
the way the user works, the workpiece and the
workstation design, as well upon the exposure
time and the physical condition of the user.
We, Desoutter, cannot be held liable for the
consequences of using the declared values,
instead of values reflecting the actual exposure,
in an individual risk assessment in a work place
situation over which we have no control.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
An EU guide to managing hand-arm vibration
can be found at http://www.pneurop.eu/uploads/
documents/pdf/PN3-02-NV_Declaration_info_
sheet_0111.pdf
All manuals and user guides at all-guides.com
We recommend a programme of health
surveillance to detect early symptoms which
may relate to noise or vibration exposure, so that
management procedures can be modified to help
prevent future impairment.
Additional Vibration Information
For making rough estimates of daily vibration
exposures, useful information may be
found in CEN/TR 15350: 2006, "Mechanical
vibration – Guideline for the assessment of
exposure to hand-transmitted vibration using
available information including that provided by
manufacturers of machinery."
OPERATING MODE
The tool can be handheld or used as fixed
spindle on a tool.
Handheld tool
● Fit the tool with a suitable fastening
accessory, then connect it to the power supply
by means of the controller.
● Hold the tool by means of the handle and
apply to the fastener to be tightened.
● Press the trigger to start the tool.
● The tool stops when the preset torque is
reached.
● For each second of operation, the motor
needs to rest for 3 seconds.
● Failure to do so may result in motor
overheating and eventually damage.
● That will be considered as a misuse and the
warranty will not apply.
As the reaction force increases in proportion to
the tightening torque, make sure that the tool
is in perfect working order and the controller
is programmed correctly, to reduce the risk of
injury to the operator as a result of unexpected
behaviour of the tool.
Control and software
Power supply by means of ESP C LT, ESP C,
ESP CA LT, ESP CA depending on the model.
LUBRICATION
Do not apply too much grease on gears
or bearings; a thin coat shall be sufficient.
Apply a minimum quantity of grease for
easier identification of components when
assembling.
TOOLS
● No specific tools.
8 / 56
English
05/2020