Rowenta INTENSE PURE AIR CONNECT PU408 Serie Manual Del Usuario página 16

SWITCHING THE APPLIANCE ON
Setting the pollution sensors
The appliance is preset to medium sensitivity.
If the air quality indicator remains:
– poor after 2 hours in operation although the air seems to be purified
– excellent for more than 1 hour although the air seems to be polluted
you can adjust the sensor sensitivity as follows:
1. When the air purifier is off, hold down the mode setting button for 3 seconds:
2. Set the sensitivity by briefly pressing the mode setting button:
+ Blue
Low sensitivity
• Select high sensitivity if the air purifier indicates excellent air quality for more than 1 hour although the air
seems to be polluted.
• Select low sensitivity if the air purifier continues to indicate poor air quality even though it has been
operating for more than 2 hours and the air seems sufficiently purified.
3. Press 'Start/Stop' button to validate the sensitivity setting.
OPERATION
Start
Briefly press this button to switch the air purifier on or off.
• Mode button (2)
– AUTODAY and AUTONIGHT mode: if the air quality level is excellent then the device does not run.
– Press this button to select one of the four modes.The corresponding indicator will turn on to
indicate the selected mode.
– Daytime auto mode: the fan speed is set to 1,2,3 or 4.
– Nighttime auto mode:The fan speed is set to 1 or 2.
– Quiet mode:The fan speed is set to minimum. Use this mode in quiet environments.
– Turbo mode:The fan speed is set to maximum. Use this mode when air quality is poor.
Light
You can change the light intensity of the appliance as you wish or according to the time of day.
Press
1
2
3
Ionizer function (only on PU6086)
The ionizer function releases negative ions into the air. This function is switched off by default.
To activate it, briefly press button 13.
16
+ Orange
Medium sensitivity
Air quality indicator
Light up
Moderate light
Off
+ Red
High sensitivity
Control panel
Light up
Moderate light
Moderate light