Operation; Starting/Stopping The Blower - RIDGID R860430 Manual Del Operador

De sitio de trabajo de 18 v
Ocultar thumbs Ver también para R860430:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION

WARNING:
Do not allow familiarity with products to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
hearing protection. Failure to do so could result
in objects being thrown into your eyes resulting
in possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Clearing hard surfaces such as driveways and walkways
 Keeping jobsite area free from residual dusts and other
light debris
This product will accept RIDGID 18 V lithium-ion battery
packs.
For complete charging instructions, refer to the Operator's
Manuals for your RIDGID battery pack and charger models.
BATTERY PROTECTION FEATURES
RIDGID lithium-ion batteries are designed with features that
protect the lithium-ion cells and maximize battery life.
If the tool stops during use, release the trigger to reset and
resume operation. If the tool still does not work, the battery
needs to be recharged.
TO INSTALL/REMOVE BATTERY PACK
See Figure 3, page 10.
WARNING:
Always remove battery pack from your tool
when you are assembling parts, making adjust-
ments, cleaning, or when not in use. Removing
battery pack will prevent accidental starting that
could cause serious personal injury.
To install:
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.
WARNING:
Make sure the latches on the sides of the battery
pack snap in place and the battery pack is fully
seated and secure in the blower battery port
before beginning operation. Failure to securely
seat the battery pack could cause the battery
pack to fall out, resulting in serious personal
injury.
To remove:
 Depress the latches and remove the battery pack.
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be in the OFF
position when not in use or carrying at your
side. Remove battery pack when transporting
or carrying blower to avoid accidental starting,
which could result in serious injury.

STARTING/STOPPING THE BLOWER

See Figure 4, page 10.
 To start the blower, depress the switch trigger.
 To stop the blower, release the switch trigger.
7 — English

Publicidad

Tabla de contenido
loading

Tabla de contenido