Rocal X1273 Manual De Caracteristicas, Instalacion Y Funcionamiento página 14

It is possible for the paint to jump out in some areas inside the housing after a period of use, due to corrosion caused
by liquids, inadequate fuel types or others not authorized by the manufacturer, etc., In that case it will be necessary to
repaint all damaged areas before a prolonged shutdown period. (Use exclusively "Rocal heatproof spray paint").
6. PROBLEMS: CAUSE AND SOLUTION
Below is a table of possible anomalies, their causes and solutions:
PROBLEM CAUSE
1. Rejects smoke Incorrect duct
and / or
insufficient
draught
Lack of air supply for combustion
Incorrect position of registers
2. Excessive dirt Incorrect duct
on glass
Inappropriate fuel
Overly closed registers
3. Glass Excessive temperature caused by excessive
bleaching or heat in the combustion chamber
colour fading of
the plate
4. Poor heating Inappropriate fuel
Insufficient load
Combustion control registers in the wrong
position
5. Venting smoke First lighting
and / or gases
from the front,
bad smell Flammable or combustible items in the
enclosure or surrounding walls of the
equipment
Crack in the combustion chamber of the
equipment
6. Excessive draft Incorrect duct
Combustion control registers in the wrong
position
7. Poor draft
Incorrect duct
Duct dirtiness
SOLUTION
Duct servicing*:
-connection
-diameter
-leaks
-insufficient length
-outdoor access
-possible elements blocking the exit
Check vents and / or outside air supply.
Simultaneous operation with other ventilation
devices and / or heating
Setting the register
Revise section on insufficient flue (below).
Use recommended fuel
Adjust registers
Check the fuel load avoiding overheating
Adjust registers
Use recommended fuel
Adding fuel
Adjust registers
Wait for the polymerization process of the paint to
finish; this can take from one to several lightings.
Review of insulating materials such as fiberglass,
fireproof wood or any inflammable elements and
replace them.
Check for tightness and if you discover a crack,
please contact your dealer.
Duct servicing
- Excessive length
- Check Depression
- Incorrect diameter
- Check door gasket
Open the primary and secondary register following
the steps outlined in the manual. Should this not
have an effect, check that the flue duct is clean; if
it is not clean, contact a professional to clean this.
If the problem persists contact your dealer.
13