Publicidad
Idiomas disponibles
Idiomas disponibles
1
Hold the brass spigot with the threaded end facing
you. Wrap Teflon tape around the long, threaded end
of the brass spigot. Wrap the Teflon tape clockwise,
in the same direction as the threads, not against the
threads. The Teflon tape should be wrapped around
the threads three times. Too much Teflon tape can
make it difficult to thread.
Wrap Teflon tape around both ends of the hose
adapter. If linking multiple rain collectors together,
wrap Teflon tape around the threaded end of all hose
barbs as well.
Set the hose adaptor aside until Step 3.
Set the hose barbs aside until Step 7.
2
Lay the rain collector down with the pre-drilled holes towards the sky. Line up the brass spigot and insert the
end with Teflon tape into the hole on the middle of the rain collector, turning clockwise. Take care to have the
spigot straight when you insert it. Turn the spigot until you feel resistance or the hexagon end meets the rain
collector. Do not overtighten.
Teflon tape on both
ends of hose adapter
After Spigot Installed
Make sure the hose attachment part is pointing
towards the bottom of the rain collector.
Teflon tape on long,
threaded end of
brass spigot
Teflon tape on threaded
end of hose barb
page 4 of 8
Publicidad
