Publicidad
Idiomas disponibles
Idiomas disponibles
3
Screw the spigot valve onto the Teflon
tape wrapped end of the hose adapter
with thicker threads, turning clockwise.
Then, screw the other Teflon tape wrapped end of the hose adapter into the bottom threaded
hole on your rain collector, turning clockwise. Take care to have the hose adapter straight
when you insert it. Turn the hose adapter until you feel resistance, or the hexagon end meets
the rain collector. Do not overtighten.
After Spigot Valve Installed
Make sure the black open/close knob is pointing
towards the top of the rain collector.
Remove the clear or white protective plastic cap from the spigot
valve to expose the threads where you can connect a hose.
4
Stand your rain collector upright. Place the screen in the rectangular opening at the top of your rain collector.
Make sure the small black rubber barrier on one side of the screen is facing downwards, towards the inside
of your rain collector.
If you are linking multiple 50
US Gallon Dual Spigot Flat Back
Rain Barrels together, skip to
step 6.
If you have a 25 US Gallon
Rainwater Shed Collector, skip
to step 7.
page 5 of 8
Publicidad
