Troubleshooting - Pioneer VSW-1 Manual De Instrucciones

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think there is something wrong with this component,
check the points below. Sometimes the trouble may originate from another component. Thus, also check the other electrical appli-
ances also in use.
If the trouble cannot be rectified even after checking the following items, contact your dealer or nearest PIONEER service center.
Symptom
Power doesn't turn on.
No images are seen.
Video images are not
synchronized when switching is
performed.
Color is distorted when
performing input switching.
This unit inputs do not change
when the DJ mixer's fader lever
is operated.
DJ DVD player doesn't start
when DJ mixer's fader lever is
Static electricity or other external interference may cause the unit to malfunction. To restore normal operation, turn the power off and
then on again.
Cause
¶ Power cord is not connected.
¶ Cables are not connected properly, or are
loose.
¶ Connectors or plugs and jacks are dirty.
¶ Monitor power is not turned on.
¶ MODE SELECTOR switch setting differs
from the type of video signal (PAL/NTSC)
being played back.
¶ Use of a long cable causes drop in signal
level or quality.
¶ This unit's sync signal output is not
connected to the DJ DVD player, or is
loose.
¶ The setting of the connection panel's
CHROMA SYNC switch differs from the
type of video signal being played back.
¶ DJ mixer's fader start switch is in set to OFF.
¶ This unit's AUTO button is set to OFF
(indicator is off).
¶ DJ DVD player's control cable is not
connected to this unit, or is loose.
¶ DJ mixer's fader start switch is set to OFF.
¶ Control cables between DJ DVD player and
this unit, or between DJ mixer and the unit
are not connected properly, or are loose.
¶ This unit's FADER START switch is set to
OFF.
Troubleshooting
Remedy
¶ Connect power cord to wall outlet.
¶ Connect properly.
¶ Clean connectors and plugs, jacks.
¶ Turn on power to monitor.
¶ Set the MODE SELECTOR switch to
match the type of video signal being
played (PAL/NTSC).
¶ Change to shorter cables.
¶ Connect properly.
¶ Set the CHROMA SYNC switch to
match the kind of signal being played.
¶ Set DJ mixer's fader start switch to ON.
¶ Press AUTO button to ON (indicator
lights).
¶ Connect properly.
¶ Set DJ mixer's fader start switch to ON.
¶ Connect control cables properly.
¶ Press this unit's FADER START switch
to ON position.
7
<DRB1375> En