Publicidad
Idiomas disponibles
Idiomas disponibles
Dimensions(mm)
The MD2 is 86mm x 86mm and the front display is 16.5mm thick. A single gang pattress box 46mm deep is
required for mounting, and mounting holes are 60mm apart.
Wiring
Wire mains Live to terminal 1, Neutral to terminal 2 and Earth to terminal 5. Wire the load to heater: Live
to terminal 3, Neutral to terminal 4 and earth to terminal 5.
Installation
Wiring the MD2 should be carried out by a qualified electrician. Ensure power
supply to the MD2 is turned OFF before wiring or unwiring the MD2. Maximum
load is 16A / 3.6kw at 230v.
The MD2 can be used to control several Herschel heaters but the maximum
wattage of 3.6kw (3,680w) must not be exceeded. Do not use for any other
non-Herschel heating devices. INDOOR USE ONLY.
MD2 Thermostat
ENGLISH
Publicidad
