Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL DATA
definition in accordance with EN 13240
Constructive system
global thermal power in kW
Nominal thermal power in kW
power given back to water in kW
power given back to the room in kW
Hourly wood consumption in kg / h (wood with 20% humidity)
Efficiency in %
CO measured at 13% oxygen in %
smoke outlet diameter in mm
Chimney height - dimension in mm
Fluid contents of the exchanger in L (litres)
Chimney draught in Pa
Boiler connections (Ø)
Automatic discharge pipe diameter (Ø)
Exhaust gas emission in g/s – wood
Exhaust gas temperature in °C - wood
Optimal working temperature in °C
Max. working pressure in bar
Hearth opening size in mm (W x H)
Hearth size in mm (W x H x d)
Oven size in mm (W x H x d)
Type of grill
Height in mm
Width in mm
Depth in mm
Weight in kg
Fire prevention safety distances
heatable m
(30 kcal/h x m
3
(*) 200 mm diameter can be used with flue of no less than 6 m. The proposed value are indicative. The installation must, in any case, be sized and
verified according to the general calculation method in UNI EN13384-1 or by another method of proven efficiency.
(**) For those buildings in which the thermal insulation does not correspond to the instructions on heat protection, the heating volume of the
product is: favourable type of building (30 kcal/h x m
x m
).
3
With thermal insulation in accordance with the regulations regarding energy saving, the heated volume is greater. With temporary heating, in
the event of interruptions which last more than 8 hours, the heating capacity is reduced by about 25%.
IMPORTANT: The power of the connected heating system must be proportional to the power transferred to the water by the thermoproduct;
a charge which is too low does not allow regular oven operation, while a charge which is too high prevents adequate radiator heating.
The declared technical data have been achieved by burning beech wood class "A1" according to the requirement UNI EN ISO 17225-5 and wood
moisture content less than 20%. By burning a different kind of wood the efficiency of the product itself could change and some specific adjustments
on the appliance could be needed.
TECHNICAL DEsCRIPTION
Definition: thermo-product according to EN 13240.
Dal Zotto thermoheating products are ideal for holiday flats and weekend houses or as auxiliary heating all year round.
Wooden logs are used as fuel. The appliance works as an intermittent operating appliance.
The appliance is composed of painted and galvanised sheet steel and cast iron. The fireplace is found inside the boiler, is built in 4 mm thick
steel and is reinforced using welded nails. a swivelling, removable grid is found inside the fireplace. The water in the heating system circulates
in the boiler, which absorbs the heat produced in the fireplace.
Below the hearth grate there is an extractable ash drawer
Below the fireplace door there is an extractable wood drawer
The ceramic glass window (resistant up to 700°C) of the door provides a lovely view of the burning flames and prevents sparks and smoke
from getting out.
26
)
3
); less favourable type of building (40 kcal/h x m
3
TermoCARLOTTA 13 EVO - DsA
(*) 4m 250x250 Ø250 - 5m 220x220 Ø220
(Picture 8 -
A).
(Picture 6 -
C).
ENgLIsH
1
15,4
12,8
8,5
4,3
3,6
83
0,09
130
18.5
11 (1,1
)
(mm H
o
2
1 "f gas
½"M gas
9,2
302
70 - 75
Vea 1,5 – VeC 3
305 x 250
307 x 240 x 335
/
Movable - flat
962
563
552
165
Chapter Fire prevention safety
366 (**)
); unfavourable type of building (50 kcal/h
3
Publicidad
