3
Maintenance of beverage cooler
3 1Disconnect the beverage cooler
Unplug power plug to disconnect the beverage cooler.
3 2 Stop using the beverage cooler
If the beverage cooler left unused for a long time, please:
1. Unplug the beverage cooler;
2. Clean the beverage cooler;
3. Keep the beverage cooler door open.
3 3 Clean the beverage cooler
Dusts behind the beverage cooler and on the ground shall be timely
to improve the cooling effect and energy saving.
Check the door gasket regularly to make sure there are no debris.
Clean the door gasket with a soft cloth dampened with soapy water
cleaned or diluted detergent.
The interior of the beverage cooler should be cleaned regularly to
avoid odor.
Please turn off the power before cleaning interior, remove all foods,
drinks ,shelves, etc.
Use a soft cloth or sponge to clean the inside of the beverage cooler, with two
tablespoons of baking soda and a quart of warm water. Then rinse
with water and wipe clean. After cleaning, open the door and let it
dry naturally before turning on the power.
For areas that are difficult to clean in the beverage cooler (such as narrow sandwiches, gaps or
corners), it is recommended to wipe them regularly with a soft rag, soft brush, etc. and
when necessary, combined with some auxiliary tools (such as thin sticks) to ensure no
contaminants or bacterials accumulation in these areas.
Do not use soaps, detergents, spray cleaners, etc. to clean the inside of your beverage cooler
as these may create odors or contamination.
Clean the shelves with a soft cloth dampened with soapy water or diluted detergent.
Then rinse with water and dry with a soft cloth or dry naturally.
Wipe the outer surface of the beverage cooler with a soft cloth dampened with soapy water,
detergent, etc., and then wipe dry. Do not rub or scratch the surface of the glass door to prevent
the door from being broken or scratched.
Do not use hard brushes, clean steel balls, wire brushes, abrasives(such as toothpastes),
organic solvents (such as alcohol, acetone, banana oil, etc.), boiling water, acid
or alkaline items, which may damage the beverage cooler surface and interior. Boiling water
and organic solvents such as benzene may deform or damage plastic parts.
Do not rinse directly with water or other liquids during cleaning to avoid short
circuits or affect electrical insulation after immersion.
Notice:
Do not use detergent and solvent with sand or acid.
12