Publicidad
Idiomas disponibles
Idiomas disponibles
3 YEARS
L I M I T E D WA R R A N T Y
6) An operation is only performed when the bit wallet is well secured.
7) Accessories may be hot after use. Avoid contact with skin and use gloves or suitable
protective cloths to remove.
8) Wear ear protectors when using the tool for long periods. Prolonged exposure to
high-density noise can cause hearing loss.
9) Use auxiliary handle when operating to ensure safety.
Operation safety warning
1. Install or remove the bit.
Warning: switch must be o and disconnected.
Before installing or removing the bit.
Loosen the drill chuck by hand, and then insert the bit by hand-tight, then insert the
WRENCH into all three holes. Tighten it clockwise. To remove the bit, insert the wrench into
one of the holes. And then loosen the chuck counterclockwise.
2. Switch operation
Press the SWITCH BUTTON to start the tool. Loosen the button and then the tool stops
rotating. If continuous rotation is required, press the SWITCH BUTTON and the LOCK
BUTTON. Press the SWITCH BUTTON and loosen, then the button also stopped rotating.
When you need to change the rotation, adjust the round knob in the middle of the SWITCH
BUTTON. When adjusted in the '+' direction, the speed increases and will reach the
maximum speed when adjusted to the terminal. Adjust to the steering, the speed decreases
and will reach the minimum speed when it is adjusted to the terminal. And the shutdown
time is shortened.
3. Reversible operation
Warning: Check the switch operation to see if it is exible before plugging in the power.
Pressing the button and loosening it to check if the button can be reset (turned o ).
Tool rotates clockwise when hoist is turned to 'F' . And counter-clockwise, turn the lever to 'R' .
5
Publicidad
