Perel PHW2000-G-RC2 Manual Del Usuario página 4

1. Drill the holes according to the measurements below. Place a nylon plug into each hole.
2. Fix the bracket using three ST4x35 screws. Fix the heater onto the bracket using two
M6x14 screws and nuts.
5. Operation
1. Plug in the appliance.
2. Flick the on-off switch on the heater to I. The heater is now on stand-by. Next, press the
on-off button and then the 2000 W button on the remote control.
3. After use, press the on-off button on the remote control to switch the heater to stand-by.
Switch off the heater completely by flicking the on-off switch on the heater to 0.
4. Disconnect from the mains.
V. 02 – 10/01/2019
PHW2000-G-RC2
4 ©Velleman nv