Publicidad
Idiomas disponibles
Idiomas disponibles
Prior to installation, read instructions all the way through
and determine room placement.
NOTE: Be sure to include the additional width of
the posts and mounting plate dimensions when
determining placement.
ATTACHING PANELS TO POSTS
NOTE: Safe installation requires two people.
NOTE: When assembling, ensure panels and
posts are aligned at the top.
1.
To assemble a straight run, end to end, use straight
bolts and flat washers. (See Figure 1)
Figure 1
Straight Bolt
Bolt Head
Flat Washer
2. To assemble a 90° corner, use curved bolts and lock
washers. (See Figure 2)
Figure 2
Curved Bolt
Lock
Washer
3. Use a 13 mm wrench to tighten.
4. Repeat steps 1-3 until all posts and panels have
been attached. The number of posts and panels will
vary depending on room size.
ATTACHING HINGED DOOR TO POSTS
1. Align door to post. Doors swing outward, away from
the room.
PAGE 2 OF 12
INSTALLATION
Flange Nut
Panel
Flange Nut
Bolt Head
NOTE: If mounting a 10' hinged door, attach
2' filler panel before mounting door.
(See Figure 3)
Figure 3
a. If anchoring on the existing post, proceed to
part b. If anchoring on the opposite post, use
the door width to determine the proper mounting
distance and install opposite post. Take care
to measure post to post. Too large of a gap will
prevent the door from functioning properly.
b. Align door with post where it will be mounted.
Attach the hinges using the six short self-tapping
screws provided and nut driver.
NOTE: Use a screw gun with an adjustable
clutch, and take care not to over tighten and
strip the threads. DO NOT USE IMPACT TYPE GUNS.
NOTE: Holes for door and strike plate are not
pre-drilled. Apply pressure with self-tapping
screws to puncture post.
2. To install the strike plate, close the door and align
strike plate with door latch. Attach strike plate using
the two long self-tapping screws provided and nut
driver. (See Figure 4)
Figure 4
2' Filler Panel
0523 IH-8305
Publicidad
