Publicidad
Idiomas disponibles
Idiomas disponibles
Step 6:
As shown in the figure, first connect the leg circuit with the power
supply box and the controller, then connect the power cord with the
power supply box before powering on.
10
E
F
G
Instructions
Type: CTRL072B
Specifications
Height range: 72cm-120cm
Resistance rebound distance:
10MM
Gear 1
Gear 2
Gear 3
Default
800mm
900mm
1000mm
Instructions
1. Initial power-on of the product:
When connected to the power supply according to its nameplate, the
buzzer will beep twice, display the software version number for 1
second, and then display the current height. If the displayed height
is inconsistent with the actual height of the lifting leg, or the height of
the lifting leg has changed after re-assembly, reset operation is
required. Otherwise, it can be used directly according to the factory
preset.
2. Reset operation:
When the system moves to the lowest position and "BOT" appears
on the display, release the key, and then long press the down key
"▽" for 5 seconds without releasing it. Then the system enters the
reset mode and the display shows "RST". In case of emergency
during reset, you can release the "▽" key at any time, and the
system will stop running. Long press the down key "▽" again to
continue the reset. When the "Di" sound appears, the reset
operation ends and the lowest height of the desk is displayed
(default: 72.0).
Gear 4
△
△
1100mm
Up
Down
11
Publicidad
