Costway JV10884DE Instrucciones De Montaje página 7

When the lowest position is set and the system moves to the limit
position, long press the down key "▽" key for 5 seconds without
releasing it. Then the system enters the reset mode and the display
shows "RST". In case of emergency during reset, you can release
the "▽" key at any time, and the system will stop running. Long
press the down key "▽" again to continue the reset. When the "Di"
sound appears, the reset operation ends and the lowest height of
the desk is displayed.
When the controller is abnormal, "ERX" is displayed. Long press the
down key "▽" for 5 seconds without releasing it. Then the system
enters the reset mode and the display shows "RST". In case of
emergency during reset, you can release the "▽" key at any time,
and the system will stop running. Long press the down key "▽"
again to continue the reset. When the "Di" sound appears, the reset
operation ends and the lowest height of the desk is displayed
(default: 72.0).
Note: After the reset operation is completed, all parameters are
initialized to factory default values.
3. Up operation:
Press the "△" key, the desk will rise, and then stop when you
release the button;
4. Down operation:
Press the "▽" key, the desk will descend, and then stop when you
release the button;
5. Memory position operation:
When the lifting leg is stopped, long press any key of "1", "2", "3"
and "4" for more than 3 seconds, then the current height position of
the lifting leg will be saved to the corresponding key. The controller
can remember 4 height positions in total, and it is repeatable, and
can be saved after power failure. After memorizing the position,
directly press any key of "1", "2", "3" and "4", and the system will
automatically go to the memorized position of the corresponding
key. In the process of lifting the desk back to the memory position,
press any key of to stop the operation.
12
6. Menu option
Menu
Menu Setting page Default
page
Display unit P00 00/01
Lowest height P01 72-110
Highest height P02 82-120
Basic height P03 0～60
Rising
P04 0～10
resistance
sensitivity
Descending
P05 0～10
resistance
sensitivity
Comment
00: cm
0
01: inch
Setting range: 72 cm-110
cm
Each
ascending/descending
distance is 1cm. The
72
setting value should be at
least 10cm less than the
maximum height setting
value
Setting range: 82 cm-120
cm
Each
ascending/descending
120
distance is 1cm. The
setting value should be at
least 10cm more than the
minimum height setting
value
0 Reserved item
Protection function of rising
obstacles:
0: off;
05
1-10: The larger the
number, the lower the
sensitivity.
Protection function of
descending obstacles:
0: off;
05
1-10: The larger the
number, the lower the
sensitivity.
13