Publicidad
Idiomas disponibles
Idiomas disponibles
160992A536_GBH18V-36C 2/19/20 1:51 PM Page 11
Installing SDS-max®
Accessories
Clean the insert shank end of the
accessory to remove any debris, then
lightly grease with a light oil or
lubricant.
Insert accessory into the tool holder
through the dust shield 1, while twisting
and pushing inward until it sets into
place. Pull outward on the accessory to
be certain it is locked into the tool
holder (Fig. 3).
Note: The high efficiency available from
the rotary hammers can only be
obtained if sharp and undamaged
accessories are used. The "cost" to
maintain
accessories is more than offset by the
"time saved" in operating the tool with
sharp accessories.
Removing SDS-max®
Accessories
contact with skin and use proper
protective gloves or cloth to remove.
To remove an accessory, pull accessory
locking sleeve 2 backward and pull bit
forward. All accessories should be
wiped clean after removing (Fig. 4).
Auxiliary Handle
The tool must be used with the auxiliary
handle 14, which can be swiveled 360˚.
To reposition and/or swivel the handle
14, loosen the hand grip, move the
handle to the desired position along the
barrel and securely retighten the hand
grip (Fig. 5).
Quality Products Online at:
sharp
and
undamaged
Accessories may be
hot after use. Avoid
GlobalTestSupply
www.
Assembly
Fig. 3
Fig. 4
Fig. 5
A
14
-11-
2
1
2
1
C
B
.com
sales@GlobalTestSupply
Publicidad
