Publicidad
2
TO ADJUST BAGGER (if needed)
HORIZONTAL ADJUSTMENT
The tractor comes from the factory with the bagger assembly preset
in a fixed position. If necessary, this position can be adjusted to
maintain a consistent gap (A) between the fender and the bag-
ger assembly top. An ideal gap is approximately 0.25" (6 mm).
•
Insert 1/2" (13mm) wrench under bagger assembly top (1).
Do NOT remove; ONLY loosen adjustment bolt (2). Repeat
on opposite side.
•
Slide bagger assembly into proper position.
2
•
Once bagger assembly is in proper position, tighten adjust-
ment bolts (2) on both sides to 100 In-Lbs/11,2 Nm. Do NOT
overtighten.
•
Readjust if necessary.
VERTICAL ADJUSTMENT
If necessary, the vertical position of the bagger assembly can be
adjusted to maintain proper alignment (B) between the fender
and the bagger assembly top.
•
Remove bagger assembly.
•
Do NOT remove; ONLY loosen nuts (3).
•
Raise or lower the bagger support brackets (4) to proper
position and retighten nuts (3).
4
•
Replace bagger assembly onto bagger supports (4).
•
Readjust if necessary.
1
1
3
TO INSTALL BAGGER LATCH ASSEMBLY
WARNING: Shut off tractor engine and engage parking
brake before installing the bagger latch assemblies.
•
Remove two screws (1) on right-hand bagger latch assembly
(2).
Left-Hand Bagger
Latch Assembly
•
Install right-hand bagger latch assembly (3) through opening
in backplate (4).
•
Position right-hand bagger latch assembly on backplate with
tab (5) in the slot on backplate and align with mounting hole.
•
Using the two perviously removed screws (6), attach right-
hand bagger latch assembly to the backplate and tighten
firmly.
6
3
•
Install bagger latch extension spring (7) as shown.
•
Repeat steps for left-hand bagger latch assembly.
26
Right-Hand Bagger
Latch Assembly
2
1
5
4
7
Publicidad
