Cosmo Connected Cosmo Ride Guia Del Usuario página 5

the smartphone.
They will not be recognized by the application if this is the case.
• Pairing and configuring the Cosmo Ride and remote control This
is done via the Cosmo Connected application.
Make sure the Cosmo Ride has been charged and the remote control battery
is not discharged, launch the application, and then follow the instructions or
go to the "My Cosmo" menu to pair your devices.
• Turning the Cosmo Ride On and Off
To turn on the Cosmo Ride
- Press the touch-sensitive ON/OFF button for 3 seconds on the back of the
Cosmo Ride.
To turn off the Cosmo Ride, you can either:
- Press the touch-sensitive ON/OFF button for 3 seconds.
- Use the mobile application.
- Press the center button on the remote control for 3 seconds.
- Let the Cosmo Ride turn itself off after 2 minutes of total immobility.
• Turning the remote control on and off
- To turn it on: press any of the buttons.
- The remote control automatically turns off after
immobility.
• Selection of light modes
To change the light modes using the remote control, use the central button:
Press quickly to change the mode. There are different light modes: 1st
press: Position light
2nd press: Position light & warning light 3rd
press: Warning light
4th press: Position light off
A LED on the remote control is activated to confirm that the
command has been taken into account.
Important: Pressing on both turn signal buttons simultaneously will
desynchronize the Cosmo Ride and the remote control.
• Using the Turn Signals
To turn the turn signals on/off, use the remote control: A
single click will activate the turn signal.
A second click will deactivate the turn signal.
Without deactivation, the turn signal goes off by itself after
seconds. A LED on the remote control is activated to confirm that the
2 minutes of
15