Installing And Programming; Tools And Materials Required; Initial Conditions And Checks; Environmental Conditions - Erreka CLEVER01 Manual Del Instalador

INSTALLING AND PROGRAMMING

1

TOOLS AND MATERIALS REQUIRED

• Set of screwdrivers
• Electrician's scissors
• Marker pencil
2

INITIAL CONDITIONS AND CHECKS

Initial installation conditions

Ensure the operator is correctly installed in the
shutter gate.

Environmental conditions


This device is not suitable for installation in
inflammable or explosive environments.
Electrical power supply installation

Ensure the direct current connection and
installation fulfil the following requirements:
• The nominal voltage of the installation must
coincide with that of the control panel.
• The installation must be able to support the
power consumed by all the automatic key
devices.
• The installation must be earthed.
3

CONTENT

24
Installation Manual
• Drill and broaches
• Electrical cables

A 230Vac / 50Hz (CLEVER01) or 125Vac / 60Hz
(CLEVER01M) power connection is required.

Check that the admissible environmental
temperature range for the control panel is
suitable for the location.
• The electrical installation must comply with
low voltage regulations.
• The installation elements must be properly
secured and in a good state of conservation.
• The direct connection point must be high enough
to be out of the reach of children.

If the electrical installation does not comply
with the foregoing requirements, repair before
installing the automatic key device.
1 Open the package and remove the contents from
within.
}
Discard the packaging in an environmentally
friendly manner, using recycling containers.
 Do not leave the packaging within the reach
of children or handicapped people, as it may
cause injury.
2 Check the content: control panel with box and
instructions manual.

Should it be noticed that a piece is missing or
deteriorated, contact the nearest technical service.
I166A