Technoline WS 9059 Manual De Instrucciones página 15

changes the volume 4 times whilst the alarm signal is
heard.
Switching off the alarm signal
When the alarm is ringing, press any button except the "
to stop the alarm signal. It is not necessary to reactivate the
alarm. It will ring again this time next day.
Snooze function
When the alarm is ringing, touch the "
alarm mode will to get to SNOOZE mode. The alarm signal
sounds again after 8 minutes.
RF Transmission Procedure

The RX automatically start receiving transmission from
remote sensor for pool temperature after batteries inserted.

The remote sensor will automatically transmit temperature
signal to the RX Station after batteries inserted.

If the RX failed to receive transmission from remote sensor
("- -.-"display on the LCD), press and hold "CH" button for
2 seconds to receive transmission manually, RF icon
flashes on the LCD.

Press "CH" button to query CH2, CH3 data or cyclic display,
When the symbol
three channels will be displayed circularly.
Query Maximum/minimum numerical value

When the indoor / outdoor temperature and humidity are
shown in the LCD, The production began to record
temperature
numerical value.

Press once MEM button, the LCD will display maximum
value of temperature and humidity, The LCD will display the
minimum value of temperature and humidity if you press
once MEM button again when the maximum value is
displayed. At the same time, there are "MAX" or "MIN"
displayed on the LCD.

The arrow in the lower right corner of the screen indicates
the maximum and minimum outdoor temperature:
appears, it means that the data of
and humidity maximum
EN6
" button and the
and minimum
"