Peach PB200-60 Instrucciones De Manejo página 5

1
Instructions for use
A On/off switch
B Ready lamp
C Start panel
D Wait lamp
E Cooling slots
F Binding tray
G Cooling stand
Operation
How to achieve optimal results in ther-
mal binding:
1. Connect the appliance to the power
supply and press the on/off switch
(A). The red Wait lamp (D) lights up:
the appliance heats up to operating
temperature.
2. After approx. 2 minutes, the appli-
ance has reached its optimal opera-
ting temperature. The green Ready
lamp (B) lights up. The appliance tells
you that it is ready by emitting an
acoustic signal.
3. Select the right Peach thermal
binding folder and put the pages
that you want to bind into this.
4. Take the folder and tap it once or
twice with its spine against the table
or desk surface.
Number of sheets (80g/m
Folders thickness in mm
* Repeat 5 times step 6 and 7. Take the folder and tap it four or five times with
its spine against the table or desk surface. Afterwards proceed with step 8.
3T Supplies AG, Division Peach
Chaltenbodenstr. 6
CH-8834 Schindellegi
support@peach.info
www.3ppp3.com
)
2
15 20 30
1.5 2 3
5. Put the prepared thermal binding
folder into the binding tray (F) until
the spine of the folder touches the
hot plate.
6. Now press Start (C); the Ready lamp
(B) goes out and the Wait lamp (D)
lights up.
7. After approx. 40 seconds, the Ready
lamp (B) lights up. The binding
process is now completed.
8. Then put the bound folder in the
cooling stand (G) so that the binding
can cool down.
9. After 60 seconds, you will hold the
perfect binding in your hand.
10. Once you have done all your binding,
turn the appliance off by pressing the
on/off switch (A).
40 60 80
4 6 8
*
100 120 300
*
10 12
33
5