Publicidad
Idiomas disponibles
Idiomas disponibles
z Assembly and installation
Please note: remove all packaging material
from the product. Decide prior to mounting
where the product is to be mounted. Before
drilling the fixing holes, satisfy yourself that
there is no danger of drilling into or
damaging gas or water pipes or electricity
cables in the position where you are about
to drill the holes. Use a drill to drill the holes
into the masonry. Observe all safety
instructions provided in the operation and
safety manual for your drill. Otherwise there
is a risk of serious or fatal injury from electric
shock.
Please note: the fixings included are
suitable for conventional solid masonry. You
should check independently what kind of
fixings are best suited for the surface on
which you intend to mount the light. If
necessary, you should seek the advice of an
expert.
When deciding where to mount the
light, pay attention to the following:
Ensure the product illuminates the desired
„ „
area. Make sure that the motion sensor
covers the desired area.
The motion sensor has a maximum
„ „
detection range of 10m with a field of view
of approx. 120°.
Ensure that the motion sensor
„ „
position where street lighting will shine on it
at night. This may impair the function.
The recommended installation height is 2 to
„ „
4m. If possible, mount the Spotlight in a
position where it will not be exposed to dirt
or dust and is protected from rain (e.g.
under a roof overhang) and other
weathering effects.
Please note: the solar panel
positioned where it will be exposed to as
much direct sunlight as possible. Even partial
shade during the day can significantly
impair the charging process.
Orientation:
The optimum alignment is facing south.
Choose an orientation facing slightly to the
west rather than slightly to the east.
z Mounting the Spotlight
Transfer the positions of the guide holes
„ „
to the mounting point on the wall (see Fig.
A).
Drill two holes (dia. 6mm) and insert the
„ „
matching wall plugs
G).
Screw the screws
„ „
leaving a gap of approx. 3mm between the
screw head and the wall (see Fig. C).
Slot the guide holes
„ „
then slide the Spotlight along the guides to
fix it in place (see Fig. C).
If necessary, adjust the gap between the
„ „
screw heads and the mounting surface to
provide a firm seating for the Spotlight.
Mounting Model 1020-S with a spacer
You have the option of mounting the Model
1020-S with a spacer (see Fig. E) (see above
for mounting without a spacer).
Screw the spacer
4
„ „
floodlight using the screws
Screw the spacer
„ „
inserting the screws
holes
is not in a
tightening them (see Fig. G).
4
z Positioning the Spotlight/
solar panel
The Spotlight can be adjusted horizontally
(top/bottom) to an angle of up to 180° (see
Fig. D).
Loosen the two Spotlight star knobs
„ „
should be
adjust the Spotlight (see Fig. B).
2
When the desired position is obtained,
„ „
tighten the star knobs again. If necessary,
use a screwdriver to hold the screw while
tightening the star knob (due to the design,
(see Figs. C and
8
into the wall plugs
7
over the screws and
3
securely onto the
9
securely in place by
9
through the guide
7
into the wall plugs
12
GB/IE/NI/CY/MT
3
,
8
(see Fig. F).
11
and firmly
8
to
6
49
Publicidad
