Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
Assembly
1.
Turn the heater upside down and place it on a protected surface to avoid scratching it.
2.
Remove the 2 screws from the underside of the heater.
3.
Align the buckles on the support feet with the mounting holes and push the feet sideways
until they are aligned with the screw holes in the heater.
4.
Insert the screws through the holes of the support feet and tighten them until they are
securely fastened in place.
5.
After completing the installation, turn the heater upright.
Before using the product
WARNING!
•
Correctly connect the unit and do not leave it within the reach of unsupervised
children.
•
It is normal for heaters to emit an odour and smoke when they are turned on
for the first time or have not been used for a certain period of time. This will
disappear after a short while.
•
The heater must always be placed in an upright position on a horizontal surface.
If the heater tips over, turn it upright immediately.
•
Check that the power cord is intact.
•
The power supply used by this heater is 220-240V~. Make sure the rated current of the
power socket meets the requirements and has a safety grounding device, or else the
socket should be replaced.
•
Place the heater on a stable, heat-resistant and non-combustible horizontal surface
that is at least 30 cm (sides and rear) and 50 cm (front) clear of objects such as walls,
furniture and curtains.
•
Never place the heater below electrical sockets.
•
The heater is suitable for use in a 10-15 m² space, such as a living room or office.
•
Do not use the heater in a bathroom, or near to a swimming pool or other body of water.
The heater must never become wet. Do not use the heater in wet or humid conditions.
•
Make sure the air inlets are unobstructed. Do not cover the heater's air inlet or outlet
vents/grilles.
Operation
Power on the heater
Press the power button
heater.
on the control panel or on the remote control unit to power on the
22
EN
Publicidad
