LIVARNO home 1002-W Instrucciones De Uso Y De Seguridad página 49

If possible, mount the outdoor security in a
„ „
position where it will not be exposed to dirt
or dust and is protected from rain (e.g.
under a roof overhang), sun and other
weathering effects.
Take care to ensure that the outdoor
„ „
spotlight is not affected by interference from
another light source.
Do not point the motion sensor
„ „
A) towards heating fans, air conditioning
units, swimming pools or other objects with
rapidly changing temperatures.
Do not point the motion sensor towards
„ „
trees, bushes or areas where moving
animals can be detected.
Take into account that the motion sensor
„ „
responds primarily to movement across its
field of view and not so sensitively to
movement directly towards or away from it.
Mounting the outdoor spotlight
RISK OF ELECTRIC SHOCK!
Incorrect electrical installation or a
power supply voltage that is too
high can potentially cause electric shocks.
Failure to take account of that risk endangers
not only yourself but other people as well.
You should only have the product installed
„ „
by a qualified electrician.
When drilling the fixing holes, take care to
„ „
avoid drilling through wiring, cables or
pipes (e.g. water or gas pipes).
Make sure the power supply is
„ „
disconnected during installation. Switch off
the circuit-breaker for the circuit concerned
or remove the fuse. Safeguard it against
being switched on again (e.g. by
displaying a warning notice).
Observe the correct polarity when
„ „
connecting the wires to the terminal strip
. Refer to Figure C for details of how to
6
connect the wiring/supply cable to the
terminals.
Make sure that the mains power supply is
„ „
switched off.
The outdoor spotlight can be mounted
„ „
either on a straight wall or on a corner
using the wall bracket
Please note: make sure that you mount the
wall bracket the correct way round. Refer to
Figure F for guidance.
With the wall bracket
„ „
mounting position, mark the positions on
(see Fig. the wall for the fixing holes using either the
2
guide holes
corner) or guide holes
straight wall) (see Figs. E and F).
Drill two holes (dia. 6mm) and insert the
„ „
matching wall plugs
Screw the wall bracket
„ „
or corner mounting) in place by inserting
the screws (25mm)
holes
Check that the wall bracket is fixed firmly in
place.
Unscrew the gland nut
„ „
spotlight.
Remove the screws
„ „
12
to be able to access the terminal strip
attached to the cover plate.
Feed the power supply cable first through
„ „
the gland nut
grommet
plate
Connect the power supply cable to the
„ „
terminal strip
that the individual cable cores are correctly
connected. Take care to ensure that the
earth conductor
the other conductors so that if the cable is
torn away from the outdoor spotlight, the
earth conductor comes away last. Connect
the neutral conductor
marked N and the live conductor
terminal marked L so as to avoid incorrect
installation and consequent damage to the
product or personal injury.
Secure the connecting lead (inc. outer sleeve)
„ „
with the strain-relief clamp
Feed the terminal strip
„ „
16
16
(for mounting on building
18
17
(see Fig. F).
20
16
through the guide
19
/ and firmly tightening them.
17 18
11
from the cover plate
14
(see Fig. D) and pull it away far enough
, then through the cable
11
, and finally through the cover
15
before starting installation.
12
(see Fig. C). Make sure
6
is made longer than
9
to the terminal
10
6
GB/IE/NI/CY/MT
(see Fig. F).
in its intended
(for mounting on
(for straight-wall
from the outdoor
6
to the
8
(see Fig. C).
7
back into the
49