SNOWJOE 24V-X2-SB22 Manual Del Operador página 13

8. Some parts of the snow blower may freeze under extreme
temperature conditions. Do not attempt to operate the
snow blower with frozen parts. If the parts freeze while the
snow blower is in use, stop the snow blower, remove the
batteries, and inspect for frozen parts. Free all parts before
restarting or operating the snow blower.
Never force controls that have frozen.
9. When working on pebbles, gravel, or unpaved surfaces,
avoid throwing loose surface material along with the snow
by pushing down on the handle to raise the scraper at the
base of the unit above the pebbles or gravel.
Headlights
The snow blower is equipped with two headlights that can be
used to illuminate the forward path in the dark. The headlights
will be turned on once the machine is started by depressing
the safety switch button and pulling the ON/OFF trigger
(Fig. 21).
NOTE: The lights will only turn ON when the snow blower is
running. The lights will automatically turn off 30 seconds after
the machine powers off.
m
WARNING
Never direct the snow discharge chute at the
operator, at bystanders, at vehicles, or at nearby
windows. The discharged snow and foreign objects
accidentally picked up by the snow thrower can
cause serious damage and personal injury.
Always orient the discharge chute in the opposite
direction from where you, bystanders, surrounding
vehicles, or windows are located.
Changing Throw Direction and
Throw Height
1. The discharge chute can be adjusted 180 degrees by
rotating the chute crank. Rotate the chute control crank
clockwise to move the discharge chute to the left and
counterclockwise to move the chute to the right (Fig. 22).
Fig. 22
Discharge chute
m
Chute crank
13
2. The chute deflector on the top of the discharge chute
controls the height of the snow stream. Loosen the knobs
to raise or lower the deflector to the desired height of
snow you wish to throw. Tighten the knobs to secure the
deflector (Fig. 23).
Fig. 23
Deflector
knob
m
WARNING
Make sure that the chute deflector snaps and locks
completely onto the discharge chute. An opening
between the discharge chute and the chute deflector
may allow foreign objects to be picked up by the
snow thrower and thrown in the direction of the
operator causing serious bodily injury.
• Do not advance the chute deflector too far
forward causing an opening to appear between
the deflector and discharge chute.
• Do not overtighten the knobs on the chute
deflector.
Maintenance
To order genuine replacement parts or accessories for the
Snow Joe 24V-X2-SB22 cordless snow blower, please visit
®
snowjoe.com or contact the Snow Joe
service center at 1-866-SNOWJOE (1-866-766-9563).
m
WARNING!
Make sure to turn off the switch and
remove the batteries before performing any maintenance task
on your snow blower.
Lifetime Lubrication (Motor + Auger)
Lubrication is not necessary and may damage the unit.
The snow blower is lubricated for lifetime use at the factory
before shipment.
General Maintenance Tips
1. Do not attempt to repair the machine unless you have the
proper tools and instructions for disassembly and repair of
the machine.
m
+ Sun Joe customer
® ®