Siefken SCHOCK DAMON SD15 Manual De Instrucciones página 25

2. Power switch
Ensure that the power switch is in the position of OFF. If the plug is connected to power recep-
tacle while the power switch is in ON position, the demolition hammer will start operation
immediately, which can cause serious accident!
3. Extension cord
When the work area is removed from the power source, use an extension cord of su cient thic-
kness and rated capacity. The extension cord should be kept as short as practicable.
Operation
1. Switch action
Switch on Press the switch towards ① direction
Release the switch towards ② direction
Switch off
If continuous Operation, turn on the switch and then push in
The lock button, to stop from the locked Position, just press
the Switch fully, then Release it.
Note:
Sometimes the power tool does not begin the striking the stroke even the motor keep run-
ning, because oil inside become thick. If the power tool is used at a low temperature, or it is
used after a long idle time, this demolition hammer should be kept running for above 5 minu-
tes to warm up.
Mounting tool bits
Warning: before do it, make sure unplug the machine!
Built to Exceed 3 YEARS
L I M I T E D WA R R A N T Y
8