Engel DVB-T Full HD Manual De Usuario página 62

Software Guidelines
1. From the "ComPort" combo box choose the correct USB port on your PC that con-
nects the MV7470 and press "Connect". To find out, go to the Control Panel of your
PC (System / hardware / Device Manager / Ports / USB Serial Port)
2. Once the software has successfully connected with the device, it will automati-
cally download all the settings of the MV7470.
3. The DVProbe consists of four sub-categories as described below:
· DVB-T Settings – Parameters regarding the modulator part
· Encoder Settings – Parameters regarding the H.264 encoder
· Multiplexer Settings – Parameters regarding the multiplex part
· System Settings – Parameters regarding system information
1. DVB-T Settings
In this category the user is able to adjust several parameters of the modulator RF
output part, as described below:
1.1 Channel - Output channel selection (VHF:5-12 & UHF:21-69)
1.2 Bandwidth - Bandwidth selection
1.3 Constellation - Constellation selection
1.4 Modulation - Modulation selection
1.5 Guard Interval - Guard Interval selection
1.6 Code rate - Code rate selection
2. Encoder Settings
In this category the user is able to adjust parameters of the H.264 encoder, as des-
cribed below:
2.1 Input source – Select the primary input source
2.2 Video BR (Mpbs) – Set the video bitrate
2.3 Audio BR (Kbps) – Set the audio bitrate
2.4 Audio Encoding – Select the audio encoding
2.5 HDCP ON/OFF – Enables/disables HDCP
3. Multiplexer Settings
In this category the user is able to adjust parameters of the MV7470 multiplexer, as
described below:
62