global_main.book.book Page 28 Monday, February 21, 2022 11:13 AM
OPERATION
28
Cold Wash
Use this option to save energy by using cooler
water while increasing the wash and rinse times to
maintain wash performance.
• Wash time will increase up to several minutes
with this option.
• For best wash results, only wash small loads with
this option.
Follow the next steps to use a special
option.
1
Press the Power button.
2
Select a washing programme.
3
Customize the washing programme (Temp.,
Spin, and Soil) as necessary.
4
To use special options, press Fresh Care or
Cold Wash button.
5
Press the Start/Pause button.
Using Basic Options
You can customize the programmes by using the
following basic options:
Pre Wash
This option is recommended when washing a
heavily soiled load.
1
Press the Power button.
2
Select a washing programme.
3
Press the Pre Wash button as necessary.
4
Press the Start/Pause button.
Add Item
You can use this option in order to add or remove
clothes after the washing programme has started.
1
Press the Power button.
2
Select a washing programme.
3
Press the Start/Pause button.
4
Press the Add Item button as necessary.
5
Open the door after it unlocks itself and add or
remove necessary clothing items.
6
Close the door and press the Start/Pause
button.
NOTE
• For safety reasons, the door remains locked
when the water level or temperature inside of
the drum is high. It is not possible to add clothes
at this time.
Delay Wash
You can set this function so that the appliance
starts automatically and finishes after a specified
time interval.
1
Press the Power button.
2
Select a washing programme.
3
Press the Delay Wash button as necessary.
4
Press the Start/Pause button.
NOTE
• Except for LED of the Delay Wash button, all
LEDs on the control panel will be turned off
within 20 minutes. This feature may vary
depending on the model purchased.
• The delay time is the time to the end of the
programme, not the start. The actual running
time may vary due to water temperature, clothes
and other factors.
• To cancel the function, the Power button should
be pressed.
• Avoid using liquid detergent for this function.