Kohler K-1822 Guia Del Usuario página 4

Heater On/Off
Power On/Off
Lighted User Keypad
Operating Your Whirlpool
Power Turns the whirlpool pump on and off.
Up Arrow Increases the water flow.
Down Arrow Decreases the water flow.
Automatically engages when the whirlpool pump is powered on. Press the heater button
Heater
once to turn the heater off. Press the button a second time to turn the heater back on.
Indicator Bar Displays the water flow volume.
NOTE: If the whirlpool is not operating properly, consult the "Troubleshooting" section of this guide
before calling a qualified service representative.
Whirlpool
Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.
NOTICE: Do not allow the water temperature in the whirlpool to exceed 104°F (40°C). The heater will
automatically maintain the water temperature when the whirlpool is running, as long as the water
temperature does not exceed 104°F (40°C). The heater will disengage at higher temperatures.
Close the drain, then fill the whirlpool to a level at least 2" (5.1 cm) above the highest jet. Using
your hand, test the water temperature for comfort and safety. Carefully enter the bath.
Press the power icon to turn on the whirlpool pump and heater. Water will flow at medium volume.
Press the up or down arrow icons to increase or decrease the water flow. The indicator bar will
display the water flow volume.
Adjust the jets for optimum air/water mixture. Turn the jet trim clockwise to reduce the flow or
counterclockwise to increase the flow. If desired, position the jet nozzles to direct the water flow to
maximize your hydro-massage experience.
If desired, turn the heater off by pressing the heater icon. Press the button a second time to turn the
heater back on.
Press the power icon a second time to turn off the whirlpool pump and heater.
NOTE: The pump and heater will automatically stop after approximately 20 minutes of continuous
operation. If desired, press the power icon to reactivate the pump and heater.
Carefully exit the bath, then open the drain to empty the whirlpool.
1167589-5-A
Heater Indicator Light
Increases Flow
Indicator Bar -
Shows water
flow volume
Decreases Flow
Fill with water at least 2" (5.1 cm)
above the highest jet.
Turn the jet trim ring
clockwise to
decrease the flow.
Turn the jet trim ring counterclockwise
to increase the flow.
4
Position the jet
nozzles to direct
the water flow as
desired.
Kohler Co.