Descargar Imprimir esta página

Philips HI 905 Manual Del Usuario página 5

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
Table
Label with
ironing
instructions
B
C
D
Z
If you do not know what kind(s) of fabric(s) the
article has been made of, find a spot which will
be invisible when wearing or using the article to
try out the ironing temperature. (Always start at
a low temperature and increase to one which
gives the required results.)
• Pure woollen fabrics (100% wool) may be
pressed with the iron set to a steam position.
It is recommended to apply shot-of-steam and
use a dry pressing cloth.
When steam-ironing woollen fabrics, shining of
the fabric may occur. This can be prevented by
turning the article inside out and ironing the
inside.
• Velvet and other textures which rapidly acquire
shiny spots should be ironed in one direction
only (with the nap), applying only light pressure.
Always keep the iron moving.
• Iron the reverse side of synthetic materials and
silk to prevent shining spots. When ironing
Kind of
Temperature
textile
dial
Synthetic
e.g. acetate,
acrylic,
viscose,
polyamide,
polyester.
Silk
Wool
Cotton
MAX
Linen
Please note: This article cannot be ironed!
Steam-
ironing
MIN
|
|
1
|
|
A
|
2
A
MIN
|
3
MIN
coloured silk, it is not advisable to use steam as
this may cause stains.
Filling with water
steam and steam-spray)
- Position the steam tank
on a stable flat surface
and unscrew the cap of
the steam tank (C) by
turning anti-clockwise.
- Fill the steam tank with
water (max. 0.9 litre)
(fig. 2).
• You can use tapwater.
However, if the water is
very hard (hardness higher than 17 °DH /
21
°Clarke), it is advisable to use distilled
1
4
water.
5
Shot of
steam
MAX
MAX
(for steam-ironing, shot-of-
2
Jet of steam

Publicidad

loading