Publicidad
12. Check that all cables are properly routed through
the cable guide on top of the engine. See Figure 9.
Cable Guide
Figure 9
13. The extension cord is fastened with a cable tie to
the rear of the auger housing for shipping
purposes. Cut the cable tie and remove it before
operating the snow thrower.
Final Adjustments
After setting up your snow thrower, check the
adjustments as instructed below and make any final
adjustments necessary before operating the unit.
CAUTION: Perform the following test before operating
the snow thrower for the first time and at the start of
each winter season. Failure to comply with these
adjustment instructions may cause damage to the unit.
Auger Control Test
1. To check the adjustment of the auger control, push
forward the left hand control until the rubber
bumper is compressed. There should be slack in
the cable.
2. Release the control. The cable should be straight.
Make certain you can depress the auger control
against the left handle completely.
WARNING:
Over-tightening may prevent the auger from
disengaging and compromise the safety of the
snow thrower.
3. In a well-ventilated area, start the snow thrower
engine as instructed earlier in this section under the
heading Starting Engine. Make sure the throttle is set
in the FAST position.
4. While standing in the operator's position (behind
the snow thrower) engage the auger.
5. Allow the auger to remain engaged for
approximately ten (10) seconds before releasing
the auger control. Repeat this several times.
Do not over-tighten the cable.
6. With the engine running in the FAST position and
the auger control in the disengaged "up" position,
walk to the front of the machine.
7. Confirm that the auger has completely stopped
rotating and shows NO signs of motion.
If the auger shows ANY signs of rotating,
IMPORTANT:
immediately return to the operator's position and shut
off the engine. Wait for all moving parts to stop before
readjusting the auger control cable.
8. If adjustment is necessary, loosen the jam nut and
thread the cable in (for less slack) or out (for more
slack). See Figure 10.
9. Recheck the adjustment. Tighten jam nut against
the cable when correct adjustment is reached.
Auger
Cable
Drive Control & Shift Lever
1. Tip the snow thrower forward so that it rests on the
auger housing.
2. Move the shift lever all the way forward to the sixth
(6) position.
3. With the drive control released, spin the snow
thrower wheels by hand. The wheels should turn;
however, you may feel some resistance.
4. Engage the drive control. The wheels should no
longer turn.
5. Now release the drive control and spin the wheels
again.
6. Move the shift lever back to the fast reverse
position and then all the way forward again. There
should be no resistance in the shift lever and the
wheels should turn.
7. If you face resistance when moving the shift lever
or the wheels stop when they should not, loosen
the jam nut on the drive cable and unthread the
cable one turn.
8. If the wheels can still be turned when you engage
the drive control, loosen the jam nut on the drive
cable and thread the cable in one turn. Recheck the
adjustment and repeat if needed.
9. Tighten the jam nut to secure the cable when
correct adjustment is reached.
7
Jam
Nut
Figure 10
Publicidad
