Publicidad
Idiomas disponibles
Idiomas disponibles
If this Craftsman product fails due to a defect in material or workmanship within two years from the date of purchase, return it to any Sears
store, Parts & Repair Service Center, or other Craftsman outlet in the United States for free repair (or replacement if repair proves impossible).
This warranty applies for only 90 days from the purchase date if this product is ever used for commercial or rental purposes.
This warranty covers ONLY defects in material and workmanship. Sears will NOT pay for:
•
Expendable items that can wear out from normal use within the warranty period, such as cutting line, filters or spark plugs.
•
Repairs necessary because of accident or failure to operate or maintain the product according to all supplied instructions.
•
Preventive maintenance, or repairs necessary due to improper fuel mixture, contaminated or stale fuel.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
On/Off Stop Control
Fuel Cap
Muffler
Spark Plug
INSTALL AND ADJUST THE D-HANDLE
Install
1.
Place the D-handle down
on to the shaft housing and
the bottom clamp so that
the handle slants toward
the shaft grip (Fig. 1). Place
handle and clamp a
minimum of 6 inches from
the end of the shaft grip.
2.
Start screws with a flat-head
or T-25 Torx screwdriver. Do
not tighten until handle is adjusted.
CRAFTSMAN FULL WARRANTY
Starter
Rope Grip
Shaft Grip
Air Filter/
Muffler Cover
Primer Bulb
ASSEMBLY INSTRUCTIONS
Shaft Grip
Minimum 6 in.
(15.24 cm)
Bottom Clamp
Fig. 1
WARRANTY STATEMENT
KNOW YOUR UNIT
APPLICATIONS
As a trimmer:
•
Cutting grass and light weeds.
•
Edging
•
Decorative trimming around trees, fences, etc.
Other optional accessories may be used with this unit.
Throttle Control
D-Handle
Convertible™
Coupler
Trimmer
Attachment
Adjust
(4) Screws
3.
While holding the unit in the operating position (Fig. 8), position
D-Handle
the D-handle to the location that provides you the best grip.
4.
Tighten the clamp screws evenly until the D-handle is secure.
INSTALLING THE TRIMMER ATTACHMENT
Prior to use, make sure trimmer attachment is installed correctly.
Please refer to Operating the Convertible™ Coupler System for
proper installation.
NOTE: Remove red cap or hanger from lower shaft housing prior to
assembling to Convertible™ coupler
4
Shaft Housing
Line Cutting
Trimmer Shield
Hassle Free
®
Cutting Head
Blade
Publicidad
