Tristar BR - 1002 Manual De Instrucciones página 10

•
Do not operate your toaster near a gas supply or any electric sources of heat.
Before First Use
Clean the exterior of the toaster as described in 'Cleaning'.
Connect your toaster to a properly installed wall socket. Set the browning control (2) to the maximum setting
and slide down the carriage handle (1) until it clicks into place. Do not insert any slices of bread during this
first use and let your toaster heat up for 3-4 minutes.
During this process, the appliance may briefly produce some smoke or smell which is due on residues on the
heating elements left over from the manufacturing process.
Ensure proper room ventilation during this first use. As soon as the toaster has cooled down, it is ready for
use.
Operation
Connect your toaster to a properly installed wall socket.
o
Using the browning control (2), now select your preferred browning degree depending on the
o
thickness and freshness of the bread to be toasted.
Insert the bread slots (7), and slide down the carriage handle (1) until it clicks into place. The bread is
o
centred in the slots to ensure even browning. The pilot light (3) of the cancel button lights up. Make
sure the bun rack (6) is not attached to the toaster. (cf. "Use Of The Bun Rack")
The appliance switches off automatically as soon as the toast has the preferred browning degree. The
o
carriage handle (1) moves back into its initial position thus lifting the toast slices for easy removal. The
pilot light (3) goes out.
Should a slice of bread accidentally be wedged in the toast slot, always unplug the appliance first. As
o
soon as the toaster has cooled down, remove the slice. Never use any metal objects for removal.
To stop the toasting cycle before automatic cut-off, press the mid-cycle cancel button (3). The carriage handle
(1) moves back into its initial position lifting the toasted bread. The cancel button pilot light (3) goes out.
After several cycles, slide out the crumb tray (8), if necessary, and wipe off any crumps.
Reheat Function
Your toaster has a reheat function.
Should you wish to reheat bread already toasted earlier, simply insert the bread as described above, slide the
carriage handle (1) down and press the reheat button (4). Its pilot light lights up. The toaster automatically
stops reheating after approx. 30 seconds.
A pre-set browning degree has no effect on the reheat cycle.
Defrost Function
To activate the defrost function start the toaster as described before and press the defrost button (5). The
defrost button pilot light lights up. The toaster automatically stops at the end of defrost cycle.
Use Of The Bun Rack
Your BR-1002 toaster also features a bun rack (6).
If required, put the bun rack (6) onto the bread slots (7). Select a browning degree and start the toasting or
warm-up cycle. To set the browning degree, switch on or stop the toaster please refer to "Operation".
Cleaning
Make sure the appliance is unplugged and has cooled down before cleaning.
Regularly pull out the crumb tray (8) and clean.