Publicidad
Idiomas disponibles
Idiomas disponibles
6. Using a Metallic Block (Fig. 11).
Dimension of
workpiece being cut
Dimension of
Vise (A)
metallic block
(Should be slightly smaller
than the workpiece being cut)
Fig. 11
CUT-OFF WHEEL DISMOUNTING AND MOUNTING
WARNING:
Always turn off the trigger switch and disconnect the power plug from
the receptacle before dismounting or mounting a wheel, to prevent
accidental injury.
1. Dismounting the Cut-Off Wheel (Fig. 12).
Stopper
Fig. 12
2. Mounting the Cut-Off Wheel.
Thoroughly remove dust from the wheel washers, washer (A) and bolt, then mount the
wheel by following the dismounting procedures in reverse order.
CAUTION:
G
Confirm that the stopper has returned to the retract position after installing or
removing the cut-off wheel.
G
Tighten the bolt so that it doesn't come loose during operation of the cut-off wheel.
Confirm that the bolt has been properly tightened before the power tool is started.
All manuals and user guides at all-guides.com
When the cut-off wheel has a reduced outer
diameter, insert between the vise (A) and (B) a
metallic block slightly smaller than the dimension
Vise (B)
of workpiece being cut to use the cut-off wheel
Metallic block
economically.
(1) Press the stopper and loosen the bolt with a
NOTE: When the mounting shaft for cut-off wheel
Hex. bar
wrench
(2) Remove the bolt, washer (A), and the wheel
spanner.
cannot be fixed by pressing the stopper,
turn the bolt with a hex. bar wrench while
pressing the stopper.
The mounting shaft for cut-off wheel is
fixed when the stopper has been lowered.
washer and detach the cut-off wheel.
English
15
Publicidad
