Publicidad
INFlATION
1. Plug in the AC line cord into an AC electrical outlet. See Fig (1).
2. Slide the switch left to the inflation mark (
3. When the airbed is fully inflated to the desired firmness, slide the switch right to the Off
mark (
).
4. Lie down on the airbed to test the firmness.
5. If the sleeping surface is too hard, adjust the firmness by slowly sliding the switch right
to the deflation mark (
when the desired firmness is achieved. See Fig (5). If the airbed becomes too soft
repeat step #2 thru #5 as necessary.
Never disconnect the power line cord from the electrical outlet while the pump is operating.
Switch OFF (
) the pump first before disconnecting the power line cord.
6. Disconnect the AC line cord from the wall socket, place it inside the cord compartment.
SAVE THESE INSTRUCTIONS
(150IO) AP620C ELECTRIC PUMP ENGLISH 4.875" X 7.25" 05/06/2021
220 – 240 V
110 -120 V
√
). See Fig (4). Slide the switch left to the Off mark (
IMPORTANT
Page 3
FIg (1)
). See Fig (2).
FIg (2)
FIg (3)
FIg (4)
FIg (5)
150
English
IO
)
Publicidad
