Connecting The Pc; Closing The Casing - Auerswald COMpact 4000 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 49
Removing a Module
1.
Unlatch the board lock, for example with your
right thumb.
2.
Remove the module with your other hand.

Connecting the PC

Requirements:
• Available network socket on the PC or
in the network of the PC
1.
Insert one end of the accompanying
network cable into the network socket
on the PC or in the network of the PC.
2.
Insert the other end of the network
cable into the Ethernet socket on the
COMpact 4000 interface board.

Closing the Casing

Important: Before closing the casing, secure the Ethernet cable
with a cable tie to one of the straps provided for strain relief.
Note: The connections for the first commissioning (connection to a
PC/network and, if necessary, connection of a few terminals) must
be made before the casing is closed. Alternatively, you can
prepare them by laying a connecting cable that leads out of the
housing.
Requirements:
• Cables carefully reinserted into
the cable space after installation
1.
Place the upper edge of the
cover onto the top of the
casing.
2.
Press the lower edge of the
cover against the casing until it
clicks into place.
COMpact 4000 - Instructions V05 10/2018
Commissioning
39

Publicidad

Tabla de contenido
loading

Tabla de contenido